The manual press is a general-purpose press with a sophisticated structure. It has the characteristics of wide application and high production efficiency. It processes the metal into parts by applying strong pressure to the metal blank to cause plastic deformation and fracture of the metal. It can be widely used in cutting, punching, blanking, bending, riveting and forming processes in electronics, instruments, cameras, clocks, light industry, small hardware industry and clothing industry. So how to use the manual press in a standardized way? Today, the editor of Nalian Electromechanical has specially sorted it out.
1. The operator should be familiar with the structure and working principle of the press, correctly use the safety protection and operation control devices on the equipment, and shall not dismantle it arbitrarily.
2. Before work, check whether the hydraulic oil level, the operating system and the upper and lower limit switches are safe and reliable.
3. It is strictly forbidden to use the equipment beyond the performance and with excessive eccentricity, and it is strictly forbidden to overlap the materials for stamping.
4. When punching and shearing, do not use blunt dies.
5. When correcting the press-fit parts, make the center of the press coincide with the center of the parts.
6. The mold workpiece must be firmly balanced before use. During the production process, you must concentrate and not chat with others. When more than two people work together, they should pay special attention to the division of labor and coordination. When the press is working, it is strictly forbidden to hold the mold or workpiece with your hands, and it is strictly forbidden to put your hands into its working range.
7. During the operation of the press, pay close attention to the flexibility and reliability of the machine's operating parts and brakes, and whether the mold clamps have any bad phenomena. If any abnormality is found, the machine should be stopped immediately for inspection and treatment, and it can be used again after the fault is eliminated.
8. After the work is completed, the staff should return the cylinder to its position, cut off the power supply, and clean the work area.
9. Check the cleanliness of the pump station and oil tank regularly, and it is strictly forbidden for water, dust, and foreign matter to enter the oil tank; if there is an accidental leak in the system, sufficient hydraulic oil should be added after the fault is eliminated.
How to use a manual press
Jun 02, 2024
Send Inquiry






